mandag 24. juni 2013

Done some more LDD work on my Mk II Swingloader, and this is the current state of things:


It is turning out a lot smaller than the original it would seem, but that may be a good thing! Unfortunately, routing five axles through the articulation requires a minimum of 9 studs in the z-direction (5 for the actual axles, as well as 1 stud between each of them), in order for the rest of the build to be reasonably contained in the x- and y-directions. 

However, still a very much work in progress, will continue to update as i make more progress!

Ingen kommentarer:

Legg inn en kommentar